Page Comparison

Section

border	false

Column

width	65%

Requirements

To install Decapod 0.7, you will need to satisfy the following requirements:

Required:

Recommended:

A display capable of 1280x1024 pixels.
Cameras supported by Decapod (for capture functionality). See Decapod Stereo 3D Equipment Guide for details.

Note

You will need Mercurial to access the Decapod code repository. You can install Mercurial by running sudo apt-get install mercurial

If you are using Mercurial v1.7.4+ you may need to set the hostfingerprints.

For instructions and an example of setting the fingerprint, please refer to this: Setting Host Fingerprints for Mercurial.

In a terminal, run the following:

Code Block
hg clone https://decapod.googlecode.com/hg/ -r decapod-0.7 decapod-0.7 cd decapod-0.7/install-scripts/ sudo ./decapod-all.sh

The above commands will retrieve the 0.7 release of the Decapod source code.

Note: the Decapod 0.7 tag may not appear in the cloned source (see: http://mercurial.selenic.com/wiki/Tag)

Assuming your current directory is ./decapod-0.7/, enter the following commands in a terminal to run the different Decapod components:

Component Name	Command Line	Default HTTP address
Calibration	`python ./dewarp/dewarpServer.py`	http://localhost:8080/
Capture	`python ./capture/captureServer.py`	http://localhost:8081/
Dewarp	`python ./dewarp/dewarpServer.py`	http://localhost:8082/
Conversion	`python ./export/exportServer.py`	http://localhost:8083/

"<Some file> not found." Error
Try running through the installation steps again as shown above.

Column

width	35%

Panel

Table of Contents

Panel